RA-200

RA-200

詢價

下載

RA-200 GPS repeater Antenna
  • 產品敘述
  • 產品特性
  • 產品規格

L1-Signal GPS reradiator kit designed for receiving GPS signals indoor

  • Fully waterproof at IP66 rating
  • Cable length as long as 40m RF cable
  • Re-radiating range as long as 20-30m

RA-200, enhanced version of our best-selling RA-200 with a wider re-radiating range of 20~30 meters, is an excellent GPS L1 band signal re-radiator featuring dual antennas to re-transmit real-time GPS satellite outdoor receptions to an indoor environment. Designed to operate as a whole, the system kits are composed of a highly-sensitive external GPS antenna, precisely calibrated amplifier circuit with Helix type indoor re-radiator antenna and a built-in power supply regulator. The Helix type indoor antenna system allows multiple GPS receiver users to perform on-the-fly normal receiver operation within a closed environment, while the main GPS antenna is installed on an unmanned location outdoor. The GPS L1 signal is a 1575.42 MHz frequency; along with a 1.023 Mbps Bi-Phase shift Keying (BPSK) modulated spreading code. The input signal power at the receiving antenna is approximately -130 dBm (spread over 2 MHz). In addition, the unit is designed as plug-n-play hardware and it can be installed either permanently to a secured location or quickly at users' convenience by using either screw mounting or glass suction cup, respectively, for the indoor re-radiator helix antenna.

  • Excellent Signal Reception:
    Re-radiating distance is around 20~30 meters from the re-radiating antenna. In addition, full receiver visibility of GPS satellites outdoor comes along with an amplified re-radiated signal indoor.
  • Highly Integrated System:
    Designed to operate as a whole, the system kits are composed of a high-gain external GPS antenna, a precisely calibrated amplifier circuit with a Helix type indoor re-radiating antenna and a built-in power supply regulator that provides systems with power. The unit is designed as plug-n-play hardware and it can be installed either permanently to a secured location or quickly at users' convenience by using either screw mounting or glass suction cup, respectively, for the indoor re-radiator helix antenna.
  • Efficiency & Convenience:
    The re-radiator transmits real time data throughout the vehicle directly to an unlimited number of users. Multiple GPS receivers or hand-helds can share just one re-radiator to receive timely data.
  • Power Saving:
    Thanks to its GPS Power Saver design, the system uses an independent power supply source, saving users from the need of other power source for their GPS unit.
  • Easy-to-Setup:
    No additional cables are required and no external GPS antennas are needed to be plugged and unplugged when using a GPS receiver inside the vehicle.

Application:

  • Laboratory
  • Offices
  • Various kinds of transportation means, suchas as trucks, trains, ships sailing boats & buses
Specifications
External Antenna Electrical Specifications, TA=25°C (Cable=40m)
Description Parameter Min Typ Max Units
Frequency L1 band   1.575   GHz
Bandwidth     50   MHz
Amp Gain     --   dB
Noise Figure     1.3   dB
Output SWR     2.0:1   ratio
DC Input   4.5   5.5 Vdc
Re-Radiating Antenna System Electrical Specification, TA=25°c
Description Parameter Min Typ Max Units
Frequency L1 band   1.575   GHz
Bandwidth     20   MHz
Impedance     50   ohm
Gain     --   dB
Noise Figure     2.0   dB
Output SWR     1.6:1   ratio
Element Helix type        
Polarization RHCP        
RF Out at 1dB gain compression   -2.0   dBm
DC Input   +6   +30 Vdc
Consumption       55    mA
Re-radiating Distance: around 20~30 meters from the re-radiating antenna

*This specification is subject to change without prior notice

上一筆 下一筆